Mitsubishi Electric Mr.Slim PUHZ-RP35VHA3 Service Manual page 138

OPERATING PROCEDURE
13. Removing the compressor (MC)
(1) Remove the service panel. (See figure 1.)
(2) Remove the top panel. (See figure 1.)
(3) Remove 2 front cover panel fixing screws (5
remove the front cover panel. (See photo 3.)
(4) Remove 2 back cover panel fixing screws (5
remove the back cover panel.
(5) Remove the electrical parts box. (See photo 3.)
(6) Remove 3 valve bed fixing screws (4
and stop valve fixing screws (5
valve bed.
(7) Remove 3 right side panel fixing screws (5
rear of the unit then remove the right side panel.
(8) Remove 3 separator fixing screws (4
the separator.
(9) Recover refrigerant.
(10) Remove the 3 points of the compressor fixing
nut using a spanner or a adjustable wrench.
(11) Remove the welded pipe of compressor inlet
and outlet then remove the compressor.
Note: Recover refrigerant without spreading it in the air.
14. Removing the power receiver
(1) Remove the service panel. (See figure 1.)
(2) Remove the top panel. (See figure 1.)
(3) Remove 2 front cover panel fixing screws (5
remove the front cover panel. (See photo 3.)
(4) Remove 2 back cover panel fixing screws (5
remove the back cover panel.
(5) Remove the electrical parts box. (See photo 3.)
(6) Remove 3 valve bed fixing screws (4
and stop valve fixing screws (5
valve bed.
(7) Remove 3 right side panel fixing screws (5
rear of the unit then remove the right side panel.
(8) Recover refrigerant.
(9) Remove 4 welded pipes of power receiver inlet and outlet.
(10) Remove 2 receiver leg fixing screws (4
Note: Recover refrigerant without spreading it in the air.
10) and
10) and
10) and 4 ball valve
16) and then remove the
10) in the
10) and remove
10) and
10) and
10) and 4 ball valve
16) then remove the
10) in the
10).
138
PHOTOS
Photo 12
Valve bed
Compressor
(MC)
Separator
Separator
fixing screw
Compressor
fixing nut
Photo 13
Receiver leg
fixing screws
Valve bed
fixing
screws
Power
receiver
Inlet
Outlet
Power
receiver
Receiver
leg