Disassembly Procedure; Removing The Fan Motor - Mitsubishi Electric Mr.Slim PUHZ-RP35VHA3 Service Manual

Split-type, heat pump air conditioners
Hide thumbs Also See for Mr.Slim PUHZ-RP35VHA3:
Table of Contents

Advertisement

15

DISASSEMBLY PROCEDURE

PUHZ-RP35, 50VHA2
OPERATING PROCEDURE
1. Removing the top panel, service panel, front panel and
back panel
(1) Remove the top panel fixing screws (4
the right and two from the eft side, and detach the top
panel.
(2) Remove 1 service panel fixing screw (4
the service panel by pulling it downward. (See photo 2.)
(3) Remove the front panel fixing screws (4
front, 2 from the right and 2 from the left side, and detach
the front panel.
(4) Remove the back panel fixing screws (4
right and 3 from the rear side, and detach the back panel.

2. Removing the fan motor

(1) Remove the top panel. (See photo 1.)
(2) Remove the front panel. (See photo 1.)
(3) Remove 1 nut (M6, left-screw) and detach the propeller.
(4) Disconnect the connector CNF1 on the controller circuit
board in the electrical parts box.
(5) Loosen the clamp for the lead wire in the motor support.
(6) Remove 4 fan motor fixing screws (4
fan motor. (See photo 3.)
/VHA3
(1)
10), one from
10) and detach
10), 5 from the
10), 4 from the
18) and detach the
Photo 1
Grille
Front panel
Photo 2
Photo 3
Nut
Photo 4
Fan
motor
(MF1)
129
PHOTOS
Top panel
Service panel
fixing screw
Electrical parts box
Propeller
Fan motor fixing screws
Fan motor fixing screws
Top panel
fixing screws
Back panel
Service panel
for charge
plug
Service panel
Pull down
4 hooks
Clamp
Motor support

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents