Introduction; Scanning Sequence Examples; Errors While Scanning - Symbol DS 3478 Product Reference Manual

Introduction

This chapter describes each user preference feature and provides the programming bar codes for selecting these features for the
digital scanner.
The digital scanner ships with the settings shown in the
Default Parameters for all host and miscellaneous defaults). If the default values suit the requirements, programming is not necessary.
Set feature values by scanning single bar codes or short bar code sequences. The settings are stored in non-volatile memory and are
preserved when the digital scanner powers down.
The digital scanner communicates with the host through the digital scanner cradle. During setup, the digital scanner is paired with a
cradle, which is connected to the host through one of several interfaces (see
chapter). Each cradle can pair with up to four digital scanners.
If not using a Synapse or USB cable, select the host type (see the specific host chapter) after the digital scanner emits power-up
beeps. This is only necessary upon the first power-up when connecting to a new host.
Disconnect the power supply before changing host cables or the digital scanner may not recognize the new
host.
To return all features to their default values, scan the
menus, default values are indicated with asterisks (

Scanning Sequence Examples

In most cases, scan only one bar code to set a parameter value. For example, to set the beeper tone to high, scan the High Frequency
(beeper tone) bar code under
indicating a successful parameter entry.
Other parameters, such as Decode Session Timeout, require scanning several bar codes. See the parameter description for this
procedure.

Errors While Scanning

Unless otherwise specified, if an error is made during a scanning sequence, re-scan the correct parameter.
User Preferences Default Table on page 4-4
Set All Defaults
*
).
*
Indicates Default
*
Medium Frequency
Beeper Tone on page 4-6. The digital scanner issues a fast warble beep and the LED turns green,
Pairing on page 1-11 and the applicable host interface
bar code on page 4-5. Throughout the programming bar code
Feature/Option
User Preferences 4-3
(also see Appendix A, Standard