Switch 5 And 6 - Rotary Switch Settings (Internal Settings) - Cobalt Digital Inc 5821-D Owner's Manual

Switch 5 and 6 – Rotary Switch Settings (Internal Settings)
The 5821-D has additional configuration controls via internal register rotary selection and input (up/down)
switch. To access these controls, use rotary switches S5&6 and S7, the up/down input switch located on
the card edge.
Default convention: Use S7 (Up or Left) to increment or turn function on and (Down or Right) to
decrement or turn function off.
To save user settings, select 99 and press either the Up or Down switch.
S6S5
00: Normal User Mode
Restore to 00 prior to device use
10-19: Reserved
20-29: Reserved
30-39: Reserved
40: User H & V aspect zoom
41: User H aspect zoom
42: User V aspect zoom
43: User H aspect pan
44: User V aspect pan
50-53: Reserved
54: Background color Y
Push both buttons default to black
55: Background Cb color
Push both buttons default to black
56: Background Cr color
Push both buttons default to black
57: Enable over sampling on Analog Encoder
Default is on
58: Reserved
59: Enable SD VB
Default is on
60: User Reticule Mode Vert bars size H
61: User Reticule Mode Vert bars thickness
Make certain that the rotary switches are restored to 0, 0 before putting the 5821-D back into service.
V0.8
62: User Reticule Mode 4x3 box Horz size
63: User Reticule Mode 4x3 box Vert size
64: User Reticule Mode 4x3 box Horz Thickness
65: User Reticule Mode 4x3 box Vert Thickness
66: User Reticule Mode 16x9 box Horz size
67: User Reticule Mode 16x9 box Vert size
68: User Reticule Mode 16x9 box Horz Thickness
69: User Reticule Mode 16x9 box Vert Thickness
70: User Reticule Mode Cross Horz size
71: User Reticule Mode Cross Vert size
72: User Reticule Mode Cross Horz Thickness
73: User Reticule Mode Cross Vert Thickness
74: User Reticule Mode Y Level
75: User Reticule Mode Cb Level
76: User Reticule Mode Cr Level
74-79: Reserved
80: Horizontal offset
81: Vertical offset
82: Deserializer - reclocked output enable
83, 86: Reserved
84: SD composite soft pixel ramp at the end and
beginning of a line
85: SD-SDI/Analog Dejitter
UP = Filter ON
Down = Filter OFF
87: HD < > SD Color Matrix Bypass
UP = Bypass color matrix
Down = enable color matrix
88: Restore factory defaults
89-97: Reserved
98: NTSC Analog setup ON/OFF (default is ON)
99: Save current values
Page 8 of 13

Cobalt Digital 2005