Advertisement
Telephone base and charger installation
Telephone base installation
1.
Plug the small end
of the larger power
adapter into the power
jack at the bottom of the
telephone base.
5.
Plug the large end of
the larger power adapter
into an power outlet
not controlled by a wall
switch.
Power
adapter
Charger installation
1. Plug the small end of
the smaller power adapter
into the jack on the
underside of the charger,
then route the cord
through the slot as shown.
IMPORTANT INFORMATION
1. Use only the power adapter supplied with this product. To order a replacement power adapter,
visit our website at
1 (866) 288-4268.
Canada dial
. This power adapter is intended to be correctly oriented in a vertical or floor mount position.
3. If you receive high speed internet through your telephone line (commonly referred to as DSL),
and you are experiencing interference during telephone conversations and/or your caller ID
features are not functioning properly, install a DSL filter to the telephone line between the
telephone base and the telephone wall jack. Contact your DSL provider for a DSL filter.
www.telephones.att.com
Telephone
line cord
DSL filter
(not included)
1 (800) 222-3111.
or call
4
2.
Plug one end of the
telephone line cord into the
telephone jack at the bot-
tom of the telephone base.
3.
Route cords
through slots.
4.
Plug the other end of
the telephone line cord
into a telephone jack.
2. Plug the large end of
the smaller power adapter
into an electrical outlet.
In
Advertisement
