Removing The Wlan Module; Installing And Removing A Board - Fujitsu ESPRIMO C7xx Operating Manual

Removing the WLAN module

► Open the casing (see
► Remove the drive cage (see
► Disconnect the USB cable of the WLAN module from the connector on the
mainboard. Refer to the manual for the mainboard.
Make sure that you do not scratch the antenna on the front opening of the drive cage.
► Install the drive cage again (see
► Close the casing (see

Installing and removing a board

Please read the section "Notes on boards".
You can only install low-profile boards.
To install a board please follow the steps below.
• Opening the retaining clip for the board
• Installing a board
• Closing the retaining clip
You will learn more about the individual steps in the following sections.
Fujitsu
"Opening the casing", Page
"Removing the drive cage", Page
2
"Installing the drive cage", Page
"Closing the casing", Page
34).
37).
► Remove the screws (1).
► Pull the WLAN module out of the bay (2)
together with the USB cable.
38).
35).
System expansions
47