Troubleshooting And Tips; Help If Problems Occur; Troubleshooting; Power-On Indicator Does Not Light Up After The Device Is Switched On - Fujitsu ESPRIMO C7xx Operating Manual

Troubleshooting and tips

Troubleshooting and tips
Refer to the safety notes in the "Safety/regulations" manual and in the
started", Page 11
If a fault occurs, try to correct it as described in the following documentation:
• in this chapter
• in the documentation for the connected devices
• in the help systems of the software used
• in the documentation for your operating system

Help if problems occur

Should you encounter a problem with your computer that you cannot resolve yourself:
► Note the ID number of your device. The ID number is found on the type rating
plate on the back, the underside or the top of the casing.
► For further clarification of the problem, contact the Service Desk for your country (see the
Service Desk list or visit the Internet at "http://support.ts.fujitsu.com/contact/servicedesk"). When
you do this, please have ready the identity number and serial number of your system.

Troubleshooting

Power-on indicator does not light up after the
device is switched on
Cause
The mains power supply is faulty.
Internal power supply overloaded.
28
chapter when connecting or disconnecting cables.
Corrective measure
► Check whether the power cable is properly
plugged into the device and into a grounded
mains outlet.
► Switch the device on.
► Pull the power plug for the device out of the
grounded mains outlet.
► Wait for a moment.
► Plug the power plug back into a grounded
mains outlet.
► Switch the device on.
"Getting
Fujitsu