Installing the plastic drive cover
Depending on the drive, e.g. if you wish to remove the accessible drive, you may
need to refit the plastic drive cover again afterwards.
Installing and removing the drive cage
Removing the drive cage
Drive cage
► Open the casing (see
2
Fujitsu
"Opening the casing", Page
1
► Insert the drive cover in the direction
of the arrow into the front panel
and press the latches lightly into the
corresponding brackets.
► Close the casing (see
casing", Page
35).
34).
► Fold up the drive cage at an angle (1).
► If a drive is present, disconnect the
connector of the data and power supply
cables from the drive (2).
► Take out the drive cage from the
casing mounts.
System expansions
"Closing the
37