D-Link SharePort Go DIR-506L User Manual page 45

Section 3 - Configuration
If you chose Repeater mode you can configure the DIR-506L as a repeater for another routing device. After making changes
to the wireless network settings, click the Save Settings button.
Note: If you connect your DIR-506L to another D-Link router, you may want to change the device name of your DIR-506L
to avoid having an address/IP conflict with your other router. For more information on changing your device name, refer to
"Network Settings" on page 43.
Enable Wireless: Check Enable Wireless to enable the wireless function. If
you want to disable wireless functions, uncheck the box.
Wireless When you are browsing for available wireless networks,
Network Name:
this is the name that will appear in the list (unless Visibility
Status is set to Invisible, see below). This name is also
referred to as the SSID. For security purposes, it is highly
recommended to change from the default network name.
802.11 Mode: Select one of the following based on your needs:
• 802.11b Only: Select this for 802.11b wireless clients.
• 802.11g Only: Select this for 802.11g wireless clients.
• 802.11n Only: Select this for 802.11n wireless clients.
• Mixed 802.11g and 802.11b: Select this if you are
using a mix of 802.11g and 11b wireless clients.
• Mixed 802.11n and 802.11g: Select this if you are
using a mix of 802.11n and 11g wireless clients.
• Mixed 802.11n, 802.11g and 802.11b: Select this if
you are using a mix of 802.11n, 11g, and 11b wireless
clients.
D-Link DIR-506L User Manual
Manual Wireless - Repeater Mode
41