Turbosound flexarray Quick Start Manual page 5

Quick Start Guide
FLEX ARRAY
The movable lift point can be traversed along the spine by means of a screw which is turned by a 22mm (7/8")
socket (available from Turbosound) fitted to a speed brace or electric drill.
Turning the drive nut on the end of the shaft the lift point moves along the rear spine, tilting the load by varying
the motor connection point relative to the centre of mass of the cluster. The screw is located in polymer sealed
bearings requiring no maintenance under normal operating conditions, and is designed to last the lifetime of the
product.
A 100mm / 4" ball locking pin is supplied attached to the flybar and must be fitted through the appropriate holes
in both the moving lift point and the rear spine to ensure that when the TFA-600 cabinets are in use the vibration
cannot cause unwanted tilt adjustment. The holes are based on a vernier scale adjustment ensuring precise
alignment for tilt angles as specified in the Array Calculator. The adjustment holes do not represent the angle of
the flybar to the horizontal and are used to lock the flybar where required.
Connection to TFA-600 cabinets
Floating drop links are located at the ends of the box section enabling the easy connection of the FB-600 to the
mid/high or low frequency cabinets, ensuring that the link will easily slide into any cabinet assembly. To link the
rear of the FB-600 to the appropriate loudspeaker a pair of cabinet connection drop links is provided, each at the
correct spacing to ensure easy assembly.
FLEX ARRAY Quick Start Guide - Page - 5