Table of Contents
Advertisement
If...
Picture is not clear
Power-ring-light status
Status
Power ring does not
turn on and the
camera does not
work.
Power ring glows
steady green.
Power ring glows
steady amber.
Power ring
blinks green.
Power ring
blinks amber.
www.kodak.com/go/support
Try one or more of the following
■
To automatically set exposure and focus, press the Shutter
button halfway and hold. When the AF/AE indicator turns
green, press the Shutter button completely down to take
the picture.
■
Clean the lens
(page
■
Make sure camera is not in Close-up mode if you are more
than 21 in. (0.7 m) from your subject.
■
Place the camera on a flat, steady surface or use a tripod,
especially in high-zoom settings or in low light.
Cause
■
Turn on the camera.
■
Recharge the battery or install a new one
■
Turn Mode dial off, then back on.
■
Camera is on and ready to take a picture or video.
■
Camera is in Favorite mode.
■
Camera firmware update is in process.
■
Camera is connected to computer, USB connection
is active.
■
Date and time set with lens retracted.
■
Camera turned off while picture is being processed and
saved. Camera operating normally. Processing is
completed before power off.
■
Do not remove the card while the light is blinking.
■
Camera operating normally at power up. Take pictures
when the blinking stops.
■
Camera operating normally during connect mode to
computer.
■
Battery is low or exhausted. Recharge the
battery
(page
■
Internal camera temperature is too high. Turn the camera
off for several minutes; then turn it back on. If the
condition continues, get help
64).
2).
(page
Troubleshooting
(page
2).
60).
57
Hide quick links:
Advertisement
Table of Contents
