Siemens Gigaset Owner's Manual page 85

Appendix
Symptom
Cannot Ping the Gigaset Router
from the attached LAN, or the
Gigaset Router cannot Ping any
device on the attached LAN
Cannot connect using the web
browser
Forgot or lost the password
84
Action
Verify that the IP addresses are properly
N
configured. For most applications, you should use
the Gigaset Router's DHCP function to
dynamically assign IP addresses to clients on the
LAN. However, if you manually configure IP
addresses on the LAN, verify that the same
network address (network component of the IP
address) and subnet mask are used for both the
Gigaset Router and the LAN devices.
Make sure the device you want to Ping (and the
N
device from which you are Pinging) have been
configured for TCP/IP.
Be sure to have configured the Gigaset Router
N
with a valid IP address, subnet mask and default
gateway.
Check that you have a valid network connection
N
to the Gigaset Router and that the port you are
using has not been disabled.
Check the network cabling between the
N
management station and the Gigaset Router.
Press the Reset button on the rear panel (holding
N
it down for at least five seconds) to restore the
factory defaults.
Warning: This operation will reset all data to the fac-
tory defaults.