5.
To remove the 24 volt transformer:
a) Disconnect the two wire connectors
from the wire harness.
b) Remove the two hex-head screws and
remove the transformer.
24V Transformer Screws
Connectors
6.
To remove the main control board:
a) Remove the three hex-head screws
from the power switch bracket and move
the bracket out of the way.
3 Power Switch
Bracket Screws
b) Disconnect the six wire connectors from
the control board.
c) Press in on the locking tab and lift
the control board off each of the five
standoffs.
P8
Main Control Board
P5
Continued on the next page.
4-13
Standoff
Locking Tab
P4
P3
P6
P7