Blaupunkt Monaco Series Instruction Manual

Rechargeable bluetooth audio system

Advertisement

Advertisement

Table of Contents
loading

Summary of Contents for Blaupunkt Monaco Series

  • Page 2: Table Of Contents

    MONACO INTRODUCTION AND CONTENTS Thank you for buying this BLAUPUNKT product, which is designed to give you many years of trouble-free service. You may already be familiar with suing a similar unit, but please take time to read these instructions.
  • Page 3: Safety Instructions

    MONACO Ensure that you read all of the safety instructions before using this unit. SAFETY INSTRUCTIONS Safety Considerations • Position the power cable and other connected cables so that they are not likely to be walked on, pinched or where items can be placed on or against them. •...
  • Page 4: Preparation For Use

    MONACO Ensure that you read all of the safety instructions before using this unit. PREPARATION FOR USE Contents: 1x Main Unit, 1x User manual, 1x AC/DC adaptor, 1x AUX cable(3.5mm) Unpacking And Set Up • Remove the contents from the box and remove all packing material from the main unit. We recommend that you save the box &...
  • Page 5: Location Of Controls & Indicators

    MONACO Ensure that you read all of the safety instructions before using this unit. LOCATION OF CONTROLS & INDICATORS Top view Rear view AUX IN DC IN 16V 5V 500 mA 1 2 3 4 5 6 Front View ASSY View Power ON/ OFF/ PAUSE/ Bluetooth Button 2.
  • Page 6: Using The Ac Adaptor

    MONACO Ensure that you read all of the safety instructions before using this unit. USING THE AC ADAPTOR Connect the single plug into the “DC IN” jack on the unit’s back panel. Then, connect the AC Adaptor into the 240V AC outlet. AUX IN DC IN 16V 5V 500 mA...
  • Page 7: Getting Started

    MONACO Ensure that you read all of the safety instructions before using this unit. GETTING STARTED Charging the “MONACO” 1. AC/DC adaptor to the MONACO will automatic recharge the internal rechargeable battery. Charge unit for about 4 hours. 2. CHG. LED is solid ORANGE ON while the unit is charging and turn to CHG. GREEN LED when unit is fully charged.
  • Page 8 MONACO Ensure that you read all of the safety instructions before using this unit. GETTING STARTED This system include a USB port at the back. This allow you to charge your device using thisunit. Connect your device using the USB cable, that your device will begin to charge. Note: 1.
  • Page 9: Setting Up The Unit Bluetooth Music Receiver

    MONACO Ensure that you read all of the safety instructions before using this unit. SETTING UP THE UNIT BLUETOOTH MUSIC RECEIVER Bluetooth Device Compatibility Your Speaker connects with all Bluetooth devices that support the A2DP profile including iPad, iPhone, iPod touch, and most smartphones, laptops and tablets.
  • Page 10 MONACO Ensure that you read all of the safety instructions before using this unit. SETTING UP THE UNIT BLUETOOTH MUSIC RECEIVER To Disconnect Bluetooth device Turn off the connected device or press Volume “+” and “-“ at same time to disconnect the Bluetooth device. *The Bluetooth indicator flashes slowly after disconnect the device.
  • Page 11: Troubleshooting & Technical Specification

    MONACO Ensure that you read all of the safety instructions before using this unit. TROUBLESHOOTING AND TECHNICAL SPECIFICATION Troubleshooting If a fault occurs, first check the points listed below before taking the set for repair. If you are unable to remedy a problem by following these hints, consult you retailer or service professional.
  • Page 12: Warranty

    In the unlikely event that, your product fails to work normally, please contact the BLAUPUNKT Warranty on 1300 055 518 (Australia) and have your receipt of purchase on hand.
  • Page 13 MONACO PO BOX 6287 Silverwater NSW 1811 www.blaupunkt-australia.com.au...

Table of Contents