Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Denver cat-120
Summary of Contents for Denver cat-120
-
Page 1: Instruction Manual
Art.nr.:38-2618 CAT-120 INSTRUCTION MANUAL Car Stereo DVD/SVCD/VCD/CD/MP3/MP4 Player with PLL FM Stereo Radio Radio Data System 2.8 Inch TFT-LCD 20 0 6 7 SD/MMC Card Input (-6) Slide Down/Detachable Front Panel... -
Page 2: Before You Begin
BEFORE YOU BEGIN PRECAUTIONS: CAUTION: USE OF CONTROLS OR ADJUSTMENT OR PERFORMANCE OF PROCEDURES OTHER THAN THOSE SPECIFIED HEREIN MAY RESULT IN HAZARDOUS RADIATION EXPOSURE. THE USE OF OPTICAL INSTRUMENTS WITH THIS PRODUCT WILL INCREASE EYE HAZARD. • Keep this manual handy as a reference for operating procedures and precautions. • Always keep the volume low enough so you can hear sounds outside of the car. • Protect this product from moisture. -
Page 3: Installation
INSTALLATION PRECAUTIONS • Choose the mounting location carefully so that the unit will not interfere with the normal driving functions of the driver. • Avoid installing the unit where it would be subject to high temperatures, such as from direct sunlight or hot air from the heater, or where it would be subject to dust, dirt or excessive vibration. -
Page 4: To Support The Unit
TO SUPPORT THE UNIT . UNIT 2. RELEASE CASE 3. DASH BOARD Dashboard 4. HEX NUT 5. LOCK WASHER 6. PLAIN WASHER 7. CAR BODY 8. REAR SUPPORT STRAP 9. TAPPING SCREW 0. M5 X 5 HEX BOLT WIRE CONNECTION IN / OUT CONNECTOR Video Out (Yellow) : Yellow (Plug) DVD Audio Out (GRAY) Rear : White (L) Red (R) - Page 5 DRIVING WITH VIDEO DISPLAY By following the installation below, video will always be shown on LCD screen no matter the car is in motion or not. Steps: Connect the GRAY wire to the WHITE wire. INSTALLING REAR CAMERA FOR PARKING/REVERSE MOTION You can install an separate camera at the car rear end so when doing parking or reverse motion, the unit will automatically switch the video to the rear camera to guide the driver.
- Page 6 Locations of Parts (Main unit) 20 0 6 7 (-6) 1. POWER ON/OFF ( ) / MUTE 2. SELECT FUNCTION BUTTON 3. PRESET STATIONS (1,2,3,4,5,6) 4. ‘AF’ FUNCTION BUTTON (ALTERNATIVE FREQUENCIES) 20 0 6 7 5. ‘TA’ FUNCTION BUTTON (TRAFFIC ANNOUNCEMENT) RESET 6. ‘PTY’ FUNCTION (PROGRAM TYPE) (-6) 7. LOUDNESS BUTTON (LD) 8. MODE BUTTON (MODE) 9. BAND BUTTON (BD) 10. CD TRACK / SEARCH BUTTON 11. AUTO SEEK TUNING 12. MUTE BUTTON (MU) 13. PANEL RELEASE BUTTON ( 14. TFT-LCD DISPLAY 15. CD EJECT BUTTON ( 16. TILT BUTTON 17. MENU BUTTON...
- Page 7 Locations of Parts (Remote Control) 1. POWER ON/OFF 2. MODE 3. PLAY/PAUSE 4. TITLE 5. SELECT 6. SEEK+/SEEK- Title 7. VOL +/VOL- 8. KEYPAD 9. EJECT 10. AUDIO 11. ENTER 12. NAVIGATION 13. AUTO SEEK / PRESET SCAN / REPEAT 14. RANDOM / BAND / LOUD VOL+/- 15. DUAL 16. PROGRAM 17. TILT GOTO 18. SUBTITLE 19. SETUP 20. ANGLE 21. SLOW MOTION 22. ZOOM / A-B REPEAT 23. PLAYBACK CONTROL / STOP 24. ON SCREEN DISPLAY / GOTO 25. MUTE 26. MAIN MENU...
-
Page 8: General Operations
GENERAL OPERATIONS Turning the unit ON/OFF ( Press any button to turn on the unit. To turn off, press and hold “ ” button. Selecting a source (MODE) Press MODE repeatedly to switch between TUNER, AUX, SD/MMC and CD/DVD mode. Loading a Disc 1. Press EJ to open the front panel 2. Insert a disc into the disc loading slot Ejecting a Disc Press EJ button to eject disc Adjusting Volume • Head Unit: Rotate Head Unit: Rotate VOL knob right or left to increase or decrease volume. • Remote Control: Press Remote Control: Press VOL+ or VOL- to increase or decrease volume Mute Button • Head Unit: Press Head Unit: Press MU button to mute the sound at once. Press again to return to previous volume... -
Page 9: Listening To Radio
PICTURE SETTINGS 1. Press MENU. Select PICTURE and press VOL knob. 2. Rotate VOL knob and select the desired mode listed below: RED : 0 - 50 GREEN : 0 - 50 BLUE : 0 - 50 BRIGHTNESS : 0 - 50 CONTRAST : 0 - 50 SHARPNESS : 0 - 15 SCREEN : 16:9 / 4:3 / FULL COLOR RESET : YES/NO 3. Rotate the VOL knob until the desired sound/feature is obtained. DUAL SETTINGS DUAL is a feature that lets user control the external AV device and the head unit. For example, driver can listen to radio while the passenger at the back can watch DVD. This unit supports connection of external AV device such as portable TV through the AUDIO OUT and VIDEO OUT port. 1. Connect the AUDIO OUT and VIDEO OUT port at the back of head unit to the LINE IN of external AV device. 2. Press MENU. Select DUAL and press VOL knob. (Press DUAL key on remote) 3. Press VOL knob to turn ON DUAL feature. - Page 10 Band (BD) Pressing this key repeatedly will toggle cyclically between each band. FM1---FM2---FM3. Automatic or Manual tuning (SEEK UP / SEEK DN) When pressed short, these keys are operated as SEEK tuning mode. When pressed longer than 1 sec., they are operated as MANUAL tuning mode. Note: The unit automatically switches back to SEEK tuning mode after 5 sec. if no input was detected during MANUAL tuning mode. Auto Seek/Preset scan (P.SCN) Preset Scan (PS) - By pressing shortly, the radio plays each preset station for 5 seconds.
- Page 11 LISTENING TO CD/MP3 Currently play track no. / Total no. of tracks Currently play folder no. / Track elapsed time Total no. of folder Track file names Folder name Playback 1. Forward or Reverse: Press and hold . Unit scans at the rate of (2 - 4 - 8 - 16 - 32) times. To resume normal playback at a desired point, press 2. Skip back or forward to another chapter: Press Pressing skips to the start of the next chapter. Pressing returns to the beginning of current track. 3. Pause / Resume playback: Press 4. Stop playback: Press Searching for particular track During playback, all track file names under a folder will be displayed on the screen with their corresponding track number. You can use the navigation keypad on the remote control to access the file.
-
Page 12: Playing Dvd/Video Cd/Mp4
PLAYING DVD/VIDEO CD/MP4 Playback 1. Insert a disc. When the disc offers a menu, the menu is displayed. When a disc already inserted, press MODE to switch to disc mode. 2. On DVDs and video CDs with playback control (PBC), menu screens may appear automatically. If this happens, perform the operation described below to start playback. CAUTION: Make sure that the Video TV system settings is set correctly according to your disc your playing. If you are not sure, leave it set to “Auto”. Improper setup of TV system might cause the video to stop/skip/pause playing although audio might continue to play. You can setup video TV settings using the SETUP feature of the remote control. Refer to “SETTING UP THE DVD PLAYER” section. DVD menu Press to select the desired item, then press Enter. Video CD menu Use the number keys (“0” to “9”) to select the desired number, then press Enter. The menu screen does not appear when the PBC function is turned off. In this case, press and hold button to turn on PBC feature. - Page 13 FOR DVD You can choose between repeat playback of a title or chapter. 1. Press RPT on the remote control during playback. 2. Every time you press this button, the unit switches to the following settings: Repeat Title – Repeat the current playback title. (Press and hold RPT button) Repeat Chapter – Repeat the current playback chapter. Repeat Off – Turn repeat off. A-B Repeat Playback This feature allows you to loop playback a section of the movie starting from Point A to B. 1. Press the button to play the movie. 2. Once you have located the section you wish to playback on loop repeat, press A-B button. You will see “Rep-A” on the screen. 3. Let the movie play on until you have reached the end of the section you wish to watch on continuous loop. Once you have reached this point, press the A-B button again. “Rep-A-B” will appear on your screen. Playback will now start from Point A –B.
- Page 14 Note: •�� With some DVDs, switching between subtitles may only be possible using a menu display. With some DVDs, switching between subtitles may only be possible using a menu display. •�� You can also switch between subtitles using SET-UP MENU. You can also switch between subtitles using SET-UP MENU.
-
Page 15: Setting Up The Dvd Player
SETTING UP THE DVD PLAYER You can flexibly customize the unit to suit your preference. You can set the language and other video and audio settings so when playback starts it will always use your preferred settings. Important: 1. Load any disc into the unit before you can access the setup. 2. Press SETUP on the remote control. Settings Category Options Language OSD LANG Subtitle Select preferred options appear on screen Audio DVD Disc Version View Version Display TV Display Normal/PS, Normal/LB, Wide TV Type Auto, NTSC, PAL Angle Mark On, Off Screen Saver On, Off Audio Digital Output Off, BTS, LPCM Downmix LT/RT, Stereo Dual Mono Stereo, L-mono, R-mono, Mix-mono Dynamic Off, 1/8, 1/4, 3/8, 1/2, 5/8, 3/4, 7/8 Full LPCM Output 48KHz, 96KHz Parental... -
Page 16: Technical Specifications
The materials are recyclable as mentioned in this marking. By recycling, material recycling or other forms of re-utilization of old appliances, you are making an important contribution to protect our en�ironment. Please inquire at the community administration for the authorized disposal location. ALL RIGHTS RESERVED COPY RIGHT DENVER ELECTRONICS A/S www.denver-electronics.com...
Need help?
Do you have a question about the cat-120 and is the answer not in the manual?
Questions and answers