Reverse The Door Swing - Thetford N604.3 Installation And Owner's Manual

!
WARNING:
- Push the bottom trim piece [28] onto the front of the refrigerator.
- Put two screws [41] through the trim piece, the mounting flange, and into the floor.
- Put screws through mounting flange on the rear of the refrigerator and into the floor.
- Install the upper trim piece [40] over the control panel:
- Align the four (4) metal mounting clips on the back of the upper trim piece with the four (4) rectangular slots in the mounting
bracket of the refrigerator.
- Push the upper trim piece firmly until all four (4) mounting clips engage the rectangular slots with a "snap" sound.

Reverse the Door Swing

This refrigerator has cabinet hinges that allow you to change the direction the door opens by moving the hinges on a diagonal to the
opposite side.
1. Remove the doors (See Art02269):
- Remove the storage bins from the doors.
NOTE: Do not mix the upper and lower hinge pins because they are different.
- Remove and save the upper hinge pin [63] from each door.
- Pull the door latch and remove each door from the refrigerator.
- Remove and save the lower hinge pin [64] from each hinge.
- Remove the washer [254] and the RH lower hinge support [255] from the lower door.
2. Change the position of the cabinet hinges and the strike plate (See Art02271):
- Remove and save the screws from the strike plate [65a].
Art02269
Installation / Owner's Manual 24
Do not omit the bottom trim piece. This piece is part of the combustion seal.
63
66
255
254
64
67
67b
65a
66b
67b
66b
Art02271
66a
67a
66a
65b
67a