Installation Options; Install The Decorative Door Panel; Reverse The Door Swing; Change The Travel Latch Position - Thetford N304.3 Installation And Owner's Manual

Installation Options

Install the decorative door panel:

NOTE: The decorative panels must be 5 mm or less in thickness.
- Make a decorative door panel [38] that is (See Art00977):
- 659 mm high x 511 mm wide for N304 models.
- 787 mm high x 541 mm wide for N404 models.
- 939 mm high x 541 mm wide for N504 models.
- Push the decorative door panel into the slots [157] of the
door end caps [158].
- Push each panel retainer [37] into the slot on the edge of the
door.

Reverse the door swing:

This refrigerator has hinges that allow you to change the direction
that the door opens by moving the hinges to the opposite corner
(See Art01313).
1. Remove the door:
- Turn out and save the upper hinge pin [63].
- Open the door a small amount and pull the top of the door
away from the upper hinge of the refrigerator.
- Lift the door off of the lower hinge pin [64].
- Turn out and save the lower hinge pin.
2. Change the position of the hinges:
- Remove the screws from the upper hinge [159].
- Put this hinge on the other side as the lower hinge.
- Attach the hinge with the screws.
- Turn the lower hinge pin down into this hinge.
- Remove the screws from the lower hinge [160].
- Remove the screws from the travel latch [161].
- Put this hinge on the other side as the upper hinge.
- Attach the hinge with the screws.
3. Change the position of the travel latch (See Art01313 and
Art01571):
- Put the travel latch on the other side of the refrigerator.
- Attach the travel latch with the screws.
- Remove the screw [41] from the travel latch plate [162] on
the door.
- Remove the screw [41] from the filler plate [163] on the door.
- Put the travel latch plate on the other side of the door.
- Attach the travel latch plate with the screw.
- Put the filler plate on the other side of the door.
- Attach the filler plate with the screw.
4. Install the door:
- Put the door down onto the lower hinge pin.
- Align the holes in the upper hinge and the filler plate and hold
in this position.
- Screw the upper hinge pin down into the upper hinge and
into the door.
- Tighten all of the screws.
- Make sure the travel latch fully engages the travel latch plate.
- The travel latch should engage the travel latch plate 5
mm.
- If not, loosen the screws and adjust the height of the
travel latch.
- Tighten the screws.

Change the travel latch position:

This refrigerator allows you to put the travel latch either at the top
of the door or at the bottom of the door regardless of the door
swing direction (See Art01570 and Art01572).
1. Change the position of the travel latch plate:
- Remove the screw [41] from the travel latch plate [162] on
the door.
- Remove the screw [41] from the filler plate [163] on the
oposite end of the door.
- Put the travel latch plate on the opposite end of the door.
- Attach the travel latch plate with the screw.
- Put the filler plate on the opposite end of the door.
- Attach the filler plate with the screw.
2. Change the position of the travel latch:
- Remove the screws from the travel latch [161].
- Put the travel latch on the opposite end of the refrigerator.
- Attach the travel latch with the screws.
Owner's Manual 13