INDEX 1 Introduction Symbols used Safety instructions Identification code 2 General dimensions & model information Refrigerator enclosure 3 Power supply 4 Ventilation Working principle Position 5 Installation Handling Installation of the door panels Installation of the refrigerator...
Installation It provides you with the necessary information Only a qualified person is allowed to install for correct and safe installation of the Thetford the refrigerator and its electrical and gas appliance. Not all sections of this manual are components.
(electronic or or an authorised Thetford service partner must gas components of) the refrigerator. be able to de-install and re-install the Thetford products within the time that is allowed according • Disconnect all energy sources before you...
2 General dimensions & model information 876x469 N3185 LED+ or LCD 1250x546x628 275x469 * Depth inclusive door Refrigerator enclosure Dimensions (mm) Model A*** N3185 1250 1245 531.5-534 585-620 135 - 170 * Maintain a minimum distance of 15mm from the floor ** If there is more than 13 mm of clearance between either side of the refrigerator and the wall, fill the space with fiberglass insulation or add a baffle to eliminate the excess clearance *** For further instructions, please refer to page 9 “Installation of the refrigerator”...
3 Power supply MAIN CONNECTIONS BATTERY PACK option for E and E+ version DISPLAY MODULE POWER CONTROL MODULE BURNER CONTROL MODULE 240V DIVIDER HEATER only for N3185 SPARK CONNECTION CONNECTION ELECTRODE SWITCH 1 2 3 POWER CONTROL MODULE SOLENOID GAS VALVE AC HEATER DIODE DC HEATER...
Cable dimensions <3.5m: 6mm The refrigerator performance depends on good (preferred) <6m: 10mm ventilation. Thetford has several vents available. The choice depends on the refrigerator model Fuse high-current 20A used. Use the table below to define the correct vents. red cable (+) and white...
Position Recommended: The recommended installation is Upper vent: Ventilation can be achieved through when the vents aren’t covered. installation of an upper vent. Good: When installation is next to the caravan door, make sure that there will be at least a 25mm distance between the vents and the door.
5 Installation Installation of the refrigerator The refrigerator must be installed in a Installation of the door panels completely air-tight sealed place from the living area of the vehicle. If the sealing is not A door panel for a framed door should be fitted complete, exhaust fumes can be present in the before installing the refrigerator living area of the vehicle.
Page 10
The foam tape at the back of the installation frame is isolation foam strip only! For PVC tubes and/or water tubes within the sealing space, Thetford recommends using a heat shield or creating a minimal distance between exhaust pipes and tubes. For optimum performance the refrigerator must be level.
Page 11
Connect the electrical components (see page 6 for further details) Connect the LP gas components (see page 6 for further details) Thetford is not responsible for printing errors and reserves the right to make changes to product specifications without notice.
Page 12
E info@thetford.eu E infogb@thetford.eu GERMANY FRANCE ITALY Thetford GmbH Thetford S.A.R.L. Thetford Italy c/o Tecma s.r.l. Schallbruch 14 Parc BUROPLUS / Bâtiment 6 Via Flaminia D-42781 Haan 18, Boulevard de la Paix Loc. Castel delle Formiche Deutschland CS 80008...