Frymaster Pro Series Installation And Operation Manual page 25

4.2.2 Preparation for Use with the Magnasol Filter Assembly
1. Pull the filter pan out from the cabinet
and remove the
Magnasol filter assembly.
The filter pan is equipped with rollers in
rails, much like a kitchen drawer. The
pan is removed by lifting the front of the
pan to disengage the front rollers, then
pulling it forward until the rear rollers
clear the rails.
NOTE:
Refer to Section 4.4 for
instructions on how to disassemble and
reassemble the Magnasol filter screen
assembly.
2. Inspect the fitting on the bottom of the
Magnasol filter assembly to ensure that
the O-ring is present and in good
condition.
3. Inspect the filter pan connection fitting
to ensure that both O-rings are present
and in good condition.
crumb tray and
Remove the crumb tray and filter assembly from
the pan. Clean all components with a solution of
detergent and hot water, then dry thoroughly.
Inspect the filter screen O-ring.
Inspect the filter connection fitting O-rings.
4-5