Power Cable Connection - Oki C3200n Service Manual

3.5.2 Power Cable Connection

Conditions for Power Supplies
• The following conditions apply to the power supplies of printers:
Alternate Current (AC)
Power Supply Frequency : 50, or 60 ±2 Hz
• For unstable power supplies, use voltage regulators etc.
• The maximum power consumptions of printers are 950 W. Be sure power supplies have power
supply capacities adequate for the printers.
• Make sure to turn off printers before attaching and detaching power supply cords and grounding
wires to the printers.
• Grounding wires must be connected to dedicated grounding terminals. Never connect them to
water or gas pipes, or telephone grounds, lighting conductors or other lines.
• Be sure to insert or remove power supply cords by pushing or pulling on the plugs.
• Insert power supply plugs into receptacle outlets as far as they will go.
• Do not insert or pull out power supply plugs with wet hands.
• Install power supply cords in a location where they will not be trodden, and do not place things on
them.
• Do not tie, in bundles, or knot power supply cords in use for printers.
• Do not use damaged power supply cords for printers.
• Do not use star-burst connections for printers.
• Do not connect a printer to the same receptacle outlet being used for electrical equipment other
than the printer. Connecting a printer such a receptacle outlet, particularly being used for air
conditioning, copying or shredding equipment, may cause a malfunction in the printer due to
electrical noises. If a printer is connected to such a receptacle outlet by necessity, use a
commercially available noise filter or noise-cut transformer.
• For power supply cords of printers, use only those packed with the printers.
• Do not use extension cords for printers. If they are used by necessity, select cords with a rating
of 15 A or more.
• Printers may not function correctly when used with extension cords.
• Do not turn off printers or pull out their power supply plugs while the printers are printing.
• Please disconnect printers from the mains supply if they will not be used for an extended period
of time.
Explain connections of the power cord and earth cable to customers carefully, showing the user's
manual.
42615101TH Rev.8
: 100 V ±10%
It may expose you to electric shocks or cause a fire.
Oki Data CONFIDENTIAL
51 /