Oki C3200n Service Manual page 167

3. Model C5200ne (ODA) only:
C5200n and C5200ne share a same CU-Board. (Default C5200n)
Then, C5200n to C5200ne setting must be performed.
(1) Set Destination as ODA by above method.
(2) Connect printer to PC by USB-cable.
(3) Send below command-file by Maintenance utility software.
Command-file name: set_c5200ne.pjl
(This file is offered by ftp://
(4) Power off and power on the printer.
(5) Print demo page and check model name as C5200ne.
Note1 In case of setting change C5200ne to C5200n:
(1) Send below command-file by Maintenance utility software.
Command-file name: set_c5200n.pjl
(This file is offered by ftp://
(2) Power off and power on the printer.
(3) Print demo page and check model name as C5200n.
Note2 C5200ne setting is not changed by MENU RESET (USER MAINTENANCE MENU or
SYSTEM MAINTENANCE MENU).
4. Description
C5400/C5200/C5150/C3200n/C5510 printers to Japan
domestic and overseas destinations share a ROM. Destination setting must be performed
where the ROM is used in printers to other-than-OEL destinations (destination settings default
to OEL). Destination settings are stored in ARC board/SPY board/SPA board EEPROM.
Program ROM version changes return destination settings to their initial values. Destination
setting for maintenance-use boards, which destinations are not set at the time of shipment, is
to be carried out when they are used.
If destination is OEL and Russian compatible panel is installed, you need to change CODESET
in CONFIG MENU in SYSTEM MAINTENANCE MENU to TYPE2 and reboot. [Refer to Section
5.1 System Maintenance Menu(For Maintenance Staff.]
42615101TH Rev.8
)
)
Oki Data CONFIDENTIAL
167 /