Autoformer Placement - Community ENTASYS Application Manual

QUICK START
Figure 11: Autoformer Mounting On Top of an Enclosure
Figure 12: Autoformer Mounting Below Array
A U TO F O R M E R P L A C E M E N T
The optional autoformer, ENTASYS 750-Watt Autoformer (ENT-
750T) may be located either above or below ENTASYS module(s).
When located below the module(s), the autoformer must be
attached directly to a wall or other mounting surface (Figure 12). It
is not designed to support the weight of an ENTASYS module, and
should therefore not be directly mounted to an ENTASYS module
from below.
The autoformer may be electrically connected to the input terminals
on the bottom of an ENTASYS system using the barrier strip
terminals on the top of the autoformer.
The autoformer may be mechanically attached to the top of an
ENTASYS enclosure using the Joiner Bar and the associated hardware
included with the autoformer. (See Figure 11.) Mounting the
autoformer in this manner allows the output of the autoformer to be
routed to the input of an ENTASYS module via the Dual Banana
Jumper Plug, also included.
For additional information on the ENTASYS 750-Watt Autoformer
and how it interfaces with ENTASYS modules, please refer to the
ENTASYS Installation/Operation Manual, Pages 31-32.
Community ENTASYS Application Guide - Page 15