Removing The Wax Motor & Fan - Whirlpool Personal Valet PVBN600 Service Manual

REMOVING THE WAX MOTOR & FAN
WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Replace all panels before operating.
Failure to do so can result in death or
electrical shock.
NOTE: Sharp edges may be present.
1. Unplug the clothes vitalizer or disconnect
the power.
2. Remove the twelve T-15 Torx screws from
the top component cover and remove the
cover from the unit (see page 5-2).
The components described on this page are
shown below.
Fan Wax Motor
3. To remove the wax motor:
a) Disconnect the wires from the termi-
nals.
b) Remove the two mounting screws.
c) Disconnect the linkage arm from the
slot in the damper.
Screw (1 of 2)
Wax Motor
4. To remove the fan:
a) Disconnect the two wires from the ter-
minals.
b) Unclip the four tabs from the exterior
vent grille and remove it from the unit.
c) Remove the four T-15 Torx mounting
screws.
Exterior
Vent Grille
5-5
Linkage Arm
Fan Wires
Screw (1 of 4)