Installing The Clothes Vitalizer - Whirlpool Personal Valet PVBN600 Service Manual

INSTALLING THE CLOTHES VITALIZER

57"
A
59"
TOOLS NEEDED
• Stud finder (optional)
• Drill (electric recommended)
• 5/32" drill bit (pilot hole for lag bolt)
• Tape measure
• Pencil
• Carpenter's level
• 7/16" wrench (ratchet recommended) for lag
bolts
If installing on a concrete or a concrete block
wall:
• Concrete drill bit for wall anchors (refer to
wall anchor for drill bit size)
• Hammer
24"
16"
35"
6 ft. power supply cord.
3-prong ground-type outlet
must be located within 5 ft.
of lower right corner.
12"
B
90°
* 12" minimum clearance to side wall on left
side of appliance is required for air venting.
models weight
white doors 111 lbs.
biscuit doors 111 lbs.
wood panel doors 120 lbs.
mirrored doors 132 lbs.
PARTS SUPPLIED FOR
INSTALLATION (INSIDE
ACCESSORY BOX)
• (2) 1/4" x 2" lag bolts (for wood studs)
• (2) 1/4-20" nuts
• (1) mounting bracket cover (can be painted
or covered with wallpaper)
• Separate metal mounting bracket assembly
• (6) 1/8" thick adhesive backed cabinet spac-
ers
PARTS NOT SUPPLIED FOR
INSTALLATION
• (2) 1/4" x1-1/4" lag bolts with wall anchors for
concrete or concrete block wall installations
NOTE: The lag bolt length is based on mount-
ing bracket thickness only. Add the thickness
of any wall coverings to the length of the lag
bolts/wall anchors used. Lag bolts can be ob-
tained from any local hardware store.
2-2
C
90°
overall depth depth with doors
including handle open 90 degrees
A B (left) C (right)
13-3/4" 29-3/4" 29-1/8"
13-3/4" 29-3/4" 29-1/8"
14" 30" 29-3/8"
14" 30" 29-3/8"