Whirlpool Personal Valet PVBN600 Service Manual page 14

b) Align the lower edge of the mounting
bracket assembly with the line you drew
earlier. Select and mark a hole location
on each side of the bracket that is
closest to the center of each stud.
1/4-20 nuts
align edge
with level line
c) Set the bracket aside, and drill 5/32"
holes at the marked stud locations.
drill 5/32" hole
10. To mount the clothes vitalizer to con-
crete or concrete block:
a) Align the lower edge of the mounting
bracket assembly with the line you drew
earlier. Select and mark a hole location
on each side of the bracket.
b) Set the bracket aside, and drill two
anchor holes at the marks you made.
c) Drive the wall anchors into the holes
with a hammer.
11. Mount and secure the mounting bracket
assembly to the wall with two lag bolts.
Make sure that the bracket is level.
12. Space the inside edge of the mounting
bracket nuts so they are approximately 3/8"
to 1/2" from the mounting bracket assem-
bly.
bracket nut
3/8" - 1/2"
install mounting bracket
assembly with 2 lag bolts
wood stud
wood stud shown
WARNING
Excessive Weight Hazard
Use two or more people to move and
install clothes vitalizer.
Failure to do so can result in back or other
injury.
13. Using two people, lift the clothes vitalizer
from its shipping carton.
14. Place the two keyhole slots on the mount-
ing flange at the top of the clothes vitalizer,
over the two mounting bracket assembly
nuts, and lower it so it rests on the studs.
Do not tighten the nuts at this time.
mounting bracket
assembly
stud & nut
15. Place a carpenter's level against one of
the clothes vitalizer doors, and check to
make sure that the unit is vertically level
(plumb).
spacers (as
needed)
16. If needed, apply two adhesive-backed
spacers (from the accessory box) to the
bottom rear side of the vitalizer. Additional
spacers may be stacked on top of the two
spacers if more are required.
2-4
slot
check for
level (plumb)