Removing The Dispenser Air Nozzle & Lower Air Nozzle - Whirlpool Personal Valet PVBN600 Service Manual

REMOVING THE DISPENSER AIR NOZZLE
WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Replace all panels before operating.
Failure to do so can result in death or
electrical shock.
NOTE: Sharp edges may be present.
1. Unplug the clothes vitalizer or disconnect
the power.
2. To remove the dispenser air nozzle:
a) Remove the two screws from the dis-
penser air nozzle assembly and pull it
down as far as it will go.
b) Cut the hose clamp and remove the
hose from the nozzle.
Hose Clamp
& LOWER AIR NOZZLE
Dispenser Air
Nozzle
5-12
3. To remove the lower air nozzle:
a) Unscrew the half-moon cover from the
nozzle and remove the cover.
b) Loosely thread a 5/16-18 bolt into the
threaded nozzle to help you pull the
nozzle out of the unit.
c) Insert a small screwdriver at the top of
the nozzle and pry it out.
d) Lift and pull the nozzle and remove it
from the opening.
e) Cut the hose clamp and remove the
hose from the nozzle. NOTE: Be care-
ful that the hose does not slip back
inside the liner opening.
5/16-18 Hex
Handling Bolt
Hose
Hose Clamp
Lower
Air Nozzle