Washer Fluid Check; Technical Specifications - Ford Transit Owner's Handbook Manual

1. Disconnect the electrical
connector.
2. Attach a suitable hose to the
sensor drain and direct the hose
into a suitable container.
3. Unscrew the sensor one to two
turns and allow the water to drain.

TECHNICAL SPECIFICATIONS

Vehicle fluids
Part
Engine oil
Power assisted steering
Coolant
Brake fluid
1
Rear axle
1
Under normal operating conditions the rear axle requires no maintenance.
However, in the event the rear axle becomes submerged under water, have
the fluid changed by your dealer.
engine oil, providing it meets the specification defined by WSS-M2C913-B.
Note: If you operate your vehicle in temperatures below -20°C, you must
not use SAE 10W-40 engine oil.
Topping up the oil: If you are unable to find an oil that meets the
specification defined by WSS-M2C913-B, you must use SAE 5W-30
(preferred), SAE 5W-40 or SAE 10W-40 that meets the specification defined
by either ACEA A1/B1 (preferred) or ACEA A3/B3. Using these oils can result
in longer engine cranking periods, reduced engine performance, reduced
fuel economy and increased emission levels.
Maintenance
Install in the reverse order.

WASHER FLUID CHECK

Note: The front and rear washer
systems are supplied from the same
reservoir.
Recommended fluid
Ford or Motorcraft
Formula E SAE 5W-30
2
Engine Oil
Ford Power Steering
Fluid
Motorcraft SuperPlus
Antifreeze
Ford or Motorcraft Super
DOT 4 Brake Fluid
Ford Hypoid Oil
2
You can use an alternative SAE 5W-30
139
Specification
WSS-M2C913-B
WSA-M2C195-A
WSS-M97B44-D
ESD-M6C57-A
WSS-M2C939A