Installing A Floppy Drive Or Media Card Reader (Tower Computer) - Dell Precision 390 User Manual

Installing a Floppy Drive or Media Card Reader (Tower Computer)

NOTICE: In a tower configuration with 4 hard drives, there can only be one floppy drive or Media Card Reader which must be installed in the lower 3.5-
inch drive bay. In this case, the 4th hard drive (which must be a SATA drive) will occupy the upper 3.5-inch drive bay.
1. Follow the procedures in Before You
2. Remove the computer cover (see
3. Remove the front panel. See
4. If you are installing a new floppy drive or Media Card Reader, remove the drive-panel insert (see
shoulder screws from the inside of the drive-panel insert. Attach the screws to the new drive.
1 floppy drive
5. Gently slide the drive into place in the 3.5-inch bay until you hear a click or feel the drive securely installed.
6. If you are installing a floppy drive:
a. Connect the power cable from to the back of the floppy drive.
b. Connect the data cable to the back of the floppy drive.
7. If you are installing a Media Card Reader, connect the data cable to the back of the Media Card Reader.
8. Connect the other end of the data cable to the system board connector labeled "FLOPPY" (for a floppy drive) or "FLEXBAY" (for a Media Card Reader). To
locate system board connectors, see
Begin.
Removing the Computer Cover).
Removing the Front Panel.
2 screws (4)
System Board Components.
Removing a Drive-Panel Insert) and remove the