Advertisement
When activate key A, the light will go on, key C will be flashing from max to
min. Then key C will automatic switch off.
Press key E, the light will switch on and the symbol is automatic set for
minimum speed.
Slide key D to choose the desire fan speed from lower to upper level which
is indicated on key C.
TIMER SETTING (Note : key B only function after key E is on.)
Press key B, set the time within 3 seconds before the key B flashing. If after
3 seconds without
setting the key D, it will flash back to the level according to the fan speed
setting. Key B flashing
indicated timer is on and the chimney hood will run for 5 minutes, then
automatic switch off.
Minimum cut-off time for timer is 5 minutes and maximum cut off time for
timer is 50 minutes.
MAINTENANCE
Switch off or unplug the appliance from the mains supply
before carrying out any maintenance work.
GREASE FILTER
* The grease filters should be cleaned frequently (every two months
of operation, or more frequently for heavy use). Use a warm
detergent solution.
* Grease filters are washable.
1. Remove the grease filter by pressing the latch on the filter (Fig5).
This will disengage the filter from the hood. Tilt the filter
downward and remove.
2. Wash the filters, taking care not to bend them. Allow them to be
dry before refitting.
3. To install the grease filter, press the latch on the filter again.
Make sure the filter is securely engaged after assembly.
WARNING:
10
Advertisement
