Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Whirlpool AKR6151IXS
Summary of Contents for Whirlpool AKR6151IXS
- Page 1 Instruction Manual AKR6151IXS AKR9151IXS...
-
Page 2: Important Safety Information
This manual and the appliance itself provide important safety warnings, to be read and observed at all times. CONTENTS IMPORTANT SAFETY INFORMATION INSTALLATION & USE MAINTENANCE Product Specification & Technical Parameters Model AKR6151IXS AKR9151IXS Rated Voltage 220-240V Rated Power Frequency 50Hz Light Power 2x2W... - Page 3 Important Safety Information 1. Always disconnect the hood from the power supply before carrying out any installation or maintenance operation on the appliance. 2. Installation must be carried out by a specialized technician, incompliance with the manufacturer’s instructions and local safety regulations. 3.
-
Page 4: Installation
23. Do not leave pans unattended when frying, since the cooking oil could catch fire. 24. Make sure the lamps are cold before touching them. 25. The hood is not a shelf, therefore do not overload or place objects on it. 26. -
Page 5: General Recommendations
AKR6151IXS Electrical Connection 1. Make sure the power voltage specified on the appliance rating plate is the same as the mains voltage. This information can be found inside the hood, 2. Before reconnecting the hood circuit to the power supply and checking correct operation, always make sure the power cable is correctly fitted and that it was NOT crushed in its housing during installation. - Page 6 During use To avoid any damage do not place any weights on the appliance. Do not expose the appliance to atmospheric agents. This is a heavy product; the hood should only be lifted and installed by two or more people MOUNT THE HOOD BODY Fig.1 Fig 2...
- Page 7 Fig 3 Fig 4 1. The minimum distance between the support surfaces of the cooking pots on the cooker top and the lowest part of the cooker hood must be at least 65 cm. 2. Remove all filter(s) (Fig.5) before installation. 3.
-
Page 8: Operation
3. It is suggested to keep a minimum 100cm straight line pipe between bends and elbows for better performance. Operation Normal Operation 1. “E” = turn ON/OFF the lamp 2. “B”= turn on at speed 1 3. ”C” = turn on at speed 2 4. - Page 9 3. Wash the filters in mild detergent and rinse with warm water. Allow them to dry before refitting 4. Refit them by pressing the latch on filter. 5. Please pay attention and not to bend aluminum filter during your cleaning process 6.
- Page 10 S.No. Status Reasons Solutions Lamp doesn’t Power supply not Check if the power cord is properly connected or work connected Lamp is damaged Call consumer service for support Hood is noisy Filter not properly Remove and refit the filters properly fitted Hood is not Call consumer service for support...