Quick Setup Guide - AT&T U-verse User Manual

Quick Setup Guide

1. How to connect the Base Station
STEP 1. Determine where you would like to place
the Base Station.
STEP 2A - Powering from your U-verse receiver
(within 3 feet). Connect the "square" end of the
supplied USB cable to the Base Station and the
"rectangle" end to the back of the U-verse receiver.
STEP 2B - Powering from a Wall Outlet (further than
3 feet from U-verse receiver). Connect one end of the
supplied plug-in power supply to the Base Station
and the other end to a near by wall socket.
Note: you only need to follow STEP 2A, or STEP
2B, not both.
4
Quick Setup Guide
2. How to set the clock
STEP 1. Use the +H and the +M buttons on the bottom of
? ? ? ?
the Base Station to set the hours and minutes of the clock.
STEP 2. With the remote control in the Base Station, press
STEP 2B
and hold the FIND button which will cause the clock to dim
as desired. Press and hold the FIND button again to make
clock brighter as desired.
STEP 2A.
5