Channel Control Setup Options - AT&T U-verse User Manual

Advanced Features Setup
F. Channel Control Setup Options
The channel controls (Channel Up/Down, 0-9 and LAST) will always work your AT&T U-
verse receiver. If you'd like the channel commands to be sent to different devices
depending which mode you are in, then follow the instructions in Section F-I.
F-I. Channel Control Depends on Device Selected
1. Press and hold the TV key and while holding it pressed, press the OK key for one
second.
2. Release both keys, all of the mode keys flash followed by the TV mode key light
remaining on.
3. Press and hold the LAST key for 3 seconds until the TV mode key light briefly turns off
then stays on, then release the LAST key.
4. Press and release the LAST key to save the setting. The TV mode key light turns off
indicating successful setup. The channel commands will now work for different
devices.
18
Advanced Features Setup
F-II. Channel Always Controls your AT&T U-verse receiver (Factory Default)
1. Press and hold the TV key and while holding it pressed, press the OK key for 1
second.
2. Release both keys, all of the mode keys will flash followed by the TV mode key light
remaining on.
3. Press and hold the LAST key for 3 seconds until the TV mode key light briefly turns off
then remains on.
4. Press and release the AT&T mode key. The selected mode key light remains on.
5. Press and release the LAST key to save the setting.
The AT&T mode key light will turn off indicating a successful initial setup. The channel
commands will be setup for your AT&T U-verse receiver regardless of what mode is
selected. If the selected mode key light flashes for 3 seconds and turns off, then you will
need to start over from step 1.
19