Cisco 6500PD Installation Manual page 10

IP Camera Physical Details
6
7
8
9
10 Power LED
11 Recessed reset button
12 Audio in
13 Network status LED
14 Ethernet 10/100 RJ45 socket
General Purpose I/O Terminal Block
Figure 1-3
Figure 1-3
1
Cisco Video Surveillance 6500PD IP Camera Installation Guide
1-4
SD/SDHC card slot
Focus assist button
P-iris lens connector
Audio out
shows the pin locations and descriptions.
GPIO Terminal Block Pin Locations and Descriptions
2 3 4 5 6 7 8
The IP camera is compliant with Micro SD/SDHC (up to 32GB)
and other preceding standard SD cards.
Used in conjunction with an analog display to fine tune the IP
camera focus.
Connection for the cable from a P-iris lens. For more
information, see Figure 1-4.
Audio output port for the IP camera.
Indicates whether the IP camera is receiving power.
Recessed button that reboots the IP camera or resets it to a
default state. You can use a pin or paper clip to depress it.
Depending on how long you depress the recessed reset button,
you can do either of the following:
• Reset—Press and release the recessed reset button. Wait for
the IP Camera to reboot.
Restore—Press and hold the recessed reset button until the
•
status LED rapidly blinks. All settings will be restored to
factory default. Upon successful restoration, the status
LED will blink green and red during normal operation.
Audio input port for the IP camera.
Indicates network activity.
Accepts a standard LAN cable to connect the IP camera to a
10/100BaseT router or switch.
Pin Description
1 Power +12V
2 Digital Output
3 Digital Input
4 Ground
5 AC 24V Input
6 AC 24V Input
7 RS-485+
8 RS-485–
Chapter 1 Overview