HP EliteBook 745 G2 Maintenance And Service Manual page 94

When replacing the system board, be sure that the following components are removed from
the defective system board and installed on the replacement system board:
●
Memory modules (see
●
Heat sink (see
NOTE:
●
WLAN module (see
●
WWAN module (see
Remove the system board:
1. Position the computer upright and open as far as possible.
2. Release the ZIF connector (1) to which the fingerprint reader cable is connected, and then
disconnect the fingerprint reader cable (2) from the system board.
3. Close the computer and position it upside down.
4. Disconnect the smart card reader cable (1) from the smart card reader.
5. Disconnect the VGA/USB board cable (2) from the system board.
6. Disconnect the power button board cable (3) from the system board.
7. Release the display panel cable from the routing channel (4) attached to the system board, and
then disconnect the display panel cable (5) from the system board.
8. Disconnect the speaker cable (6) from the system board.
82 Chapter 6 Removal and replacement procedures for Authorized Service Provider parts
Memory module on page
Heat sink on page
You do not have to remove the heat sink to remove the system board.
WLAN module on page
WWAN module on page
49)
74)
53)
51)