Install Switch Modules - HP Procurve Series 4100GL Installation And Getting Started Manual

2.Install Switch Modules

Install switch modules into the slots as shown in the illustration below. For
installation details, see the instructions in the manual that comes with the
module.
N o t e
Make sure you install only HP Procurve Switch GL Modules. Switch XL
Modules will fit into your Switch GL slots, but they will not operate.
Avoid any electrostatic discharge problems by handling the modules only by
their bulkheads.
The slot cover can be removed, and the module can be installed with either a
flat-bladed or Torx T-10 screwdriver. Retain the slot cover for future use.
M o d u l e


I n s t a l l a t i o n


N o t e s








Any of the supported switch modules can be installed in any of the slots.
The modules can be "hot swapped", installed after the switch is already
powered on, and normally will be immediately operational. But, if you are
replacing a module with a different type than what was previously
installed in the slot, the switch must be rebooted after the module is
installed. See "Hot Swapping the Switch Module" on page 2-21.
The modules employ "low-force" connectors. Using high force to
insert the modules is not needed and should not be used.
Make sure that you fully insert the modules. That is, press the
module into the slot until the bulkhead on the module is contacting or is
very close to contacting the front face of the switch chassis.
Once the module is fully inserted, make sure that you screw in the two
retaining screws to secure the module in place.
If you do not use one or more of the slots, make sure that the slot cover
plate is still attached over the slot for safe operation and proper switch
cooling. For safety, you should not have more than one slot uncovered
at a time.
Installing the Series 4100GL Switches
Installation Procedures
2-7