× Bookmark added
Download Print This Page

HP ProCurve 5400zl Installation And Getting Started Manual: Install Switch Modules

Procurve 5400xl series switches and zl power supply shelf.
Hide thumbs


2. Install Switch Modules

Install switch modules into the slots as shown in the illustration below. For
installation details, see the instructions in the manual that comes with the
C a u t i o n
Make sure you install only ProCurve Switch zl Modules.
Avoid any electrostatic discharge problems by handling the modules only by
their bulkheads.
The slot cover can be removed, and the module can be installed with either a
flat-bladed or Torx T-10 screwdriver. Retain the slot cover for future use.
M o d u l e
I n s t a l l a t i o n
N o t e s
Any of the supported Switch zl Modules can be installed in any of the slots.
The modules can be "hot swapped", installed after the switch is already
powered on, and normally will be immediately operational. But, if you are
replacing a module with a different type than what was previously
installed in the slot, the switch must be rebooted after the module is
installed. See "Hot Swapping the Switch Module" on
Ensure you fully insert the modules. That is, press the module into
the slot using the extractor handles, until the bulkhead on the module is
contacting the front face of the switch chassis.
Once the module is fully inserted, screw in the two retaining screws to
secure the module in place. The screws should be tightened until they are
secure, but not overtightened.
If you do not use one or more of the slots, ensure the slot cover plate is
still attached over the slot for safe operation and proper switch cooling.
For safety, you should not have more than one module slot uncovered at
a time.
Although these procedures show the 6-slot chassis, the procedures are
the same for the 12-slot chassis.
Installing the Series 5400zl Switches
Installation Procedures


   Related Manuals for HP ProCurve 5400zl

Comments to this Manuals

Symbols: 0
Latest comments: