Chapter 2–Installing an internal LTO tape drive
Reboot the server
34
1.
Secure the drive, as described in your server documentation. The
following diagrams are examples only.
1
Plastic rail
Figure 2-13 Securing full-height drive, mounting hardware used
1
Figure 2-14 Securing half-height drive, no mounting hardware used
2.
Ensure blanking plates are in place over empty bays and replace the
cover on the server.
Reboot the server to power up the tape drive and server.
Watch the boot screen carefully after installation. If there are any error or
unexpected messages go back and check the SAS cabling carefully.
M3 screws
2
Server latch
1019491–002