Install Range Hood; Make Electrical Connection - KitchenAid Ventilation Hood Installation And Use Instructions Manual

5. Rotate the blower assembly so that the exhaust collar is
facing out the back of the hood.
A
B
C
A. Exhaust blower assembly
B. Screws
C. Exhaust collar
6. Replace the screws holding the blower assembly to the hood.
7. Plug the blower motor wire back into the blower motor.
8. Screw the ground wire back onto the blower motor.

Install Range Hood

WARNING
Excessive Weight Hazard
Use two or more people to move and install
range hood.
Failure to do so can result in back or other injury.
1. Remove the terminal box cover (located on back wall of hood)
from the hood. Remove the power supply cable knockout
using a flat-blade screwdriver.
Attach strain relief in power supply cable opening so that
clamping screws are inside of range hood. Tip hood back to
its bottom surface.
2. If roof or wall cap does not have a damper, attach damper to
exhaust opening on top of the range hood using 2 small
screws from hardware package.
3. Place the range hood mounting screws close to the holes in
the cabinet bottom.
4. Lift range hood into place while feeding wiring through strain
relief.
5. Insert the screws through the clearance holes and start them
into the hood. Then, tighten screws securely.
6. Connect vent system, for either vented or recirculating, to
range hood.
7. Seal all joints with duct tape.
8. For recirculating installations, install the vent cover (not
provided) included in Recirculation Kit Part Number 4396565
in soffit or cabinet top vent opening.
8

Make Electrical Connection

WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before operating.
Failure to do so can result in death or electrical shock.
1. Disconnect power at the circuit breaker of fused circuit box.
2. Connect the white wire of the power supply cable with the
white lead in the range hood using a twist-on connector.
3. Connect the black wire of the power supply cable with the
black lead in the range hood using a twist-on connector.
WARNING
Electrical Shock Hazard
Electrically ground blower.
Connect ground wire to green ground screw in
terminal box.
Failure to do so can result in death or electrical shock.
4. Connect the green ground wire to the unused, green ground
screw.
B
A
A. Green ground screw
B. Hood wiring
C. White wires
5. Tighten strain relief screws.
6. Replace the terminal box cover.
C
D
E
F
D. Twist-on connectors
E. Black wires
F. Power supply cable