Advertisement

Read and follow all safety information carefully. The signal words used in this manual are
selected as shown below and based on an assessment of the degree of potential injury or
damage (severe or minor) and the occurrence of injury (definitely occurs or has the potential to
occur) when the warning is ignored:
DANGER!
Indicates a situation which, when not avoided, results in death or severe injury.
WARNING!
Indicates a situation which, when not avoided, has the potential to result in death or
severe injury; and/or severe property damage.
CAUTION!
Indicates a situation which, when not avoided, results or has the potential to result in
minor injury; and/or minor property damage.
Basic safety precautions should be followed, including the following:
Ensure all Local, State, and Federal Laws and Codes including health and safety guidelines are
met when installing Waterlogic Equipment. Only qualified service technicians should attempt
installation and service of Waterlogic Equipment. Always read the entire operating instructions
before using the appliance and save these instructions for future use.
DANGER!
This product can cause death or severe injury if incorrectly operated, installed or
maintained. The installation, maintenance, sanitizing and any repair must be performed by
qualified persons trained by Waterlogic International or their approved distributors only. Do
not remove any panel or cover to protect against electrical shock and exposure to UV
radiation.
DANGER!
ELECTRICAL SHOCK HAZARD. Always use a dedicated and properly grounded
outlet. Unit should be protected by ground-fault circuit interrupter (GFCI) or residual current
device (RCD) having a rated residual operating current not exceeding 30mA. Use only
Waterlogic supplied power cord. Never use extension cords or power strips to connect unit.
Do not use if the power supply cord is damaged. Always unplug from power supply prior to
servicing.
WARNING!
AUTHORIZED USE ONLY. This appliance is to be used for its intended purpose as
described in this manual. Untrained individuals who use this manual assume the risk of any
resulting property damage or personal injury. This appliance can't be used by children and
persons with reduced physical, sensory or mental capabilities or lack of experience.
WARNING!
DO NOT OPERATE IF DAMAGED. Unplug and isolate water supply if abnormal
conditions exist. Contact Waterlogic or authorized dealer for repair, service, and installation
to avoid hazards.
WL15 Manual
SAFETY ALERT SYMBOLS
SAFETY PRECAUTIONS
Page 4 – Revision: 4-15-22

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the WL15-HCS and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for WaterLogic WL15-HCS

  • Page 1 (RCD) having a rated residual operating current not exceeding 30mA. Use only Waterlogic supplied power cord. Never use extension cords or power strips to connect unit. Do not use if the power supply cord is damaged. Always unplug from power supply prior to servicing.
  • Page 2 CAUTION! USE A WATER PRESSURE REGULATOR. Waterlogic will not be responsible for injury or damage caused by excessive water pressure. Input or feed pressure must be 40 psi to 60 psi. Be aware of any potential pressure surges caused by building/municipal pumping stations.
  • Page 3 WL15 FEATURES AND BENEFITS Storage and Water Capacity The WL15 holds 4 Liters of Sparkling Water, and 1.2 Liters of Hot Water. The WL15 makes cold water by running water through stainless steel coils submerged in the sparkling water tank for instantaneous cold water.
  • Page 4 CERTIFICATIONS The Waterlogic WL15 Water Dispenser has been tested and certified to rigorous UL Standards. We believe that performance testing and certifications validate Waterlogic as a world-leader in water treatment systems. Waterlogic WL15 Water Dispenser Certifications Include UL399 – Certified Drinking Water Cooler Intertek Labs (ETL) Certified the Waterlogic WL15 Water Machine to ANSI/UL 399 Standard for Drinking Water Coolers.
  • Page 5: Specifications

    MODEL/PART DESIGNATIONS MODEL - BRAND NAME DESCRIPTION PART NUMBER Waterlogic WL15-HCS – Hot, Cold, and Sparkling WL15-HCS 15-CT-HCS Serial Number Prefix: YYMM##### (##### denotes unit #) Waterlogic WL15-HCA – Hot, Cold, and Ambient WL15-HCA 15-CT-HCA Serial Number Prefix: YYMM##### (##### denotes unit #)
  • Page 6: Shipping Specifications

    SHIPPING SPECIFICATIONS ITEM WL15 Width/Depth/Height 13”/330mm (W) x 16.5”/419mm (D) x 16.5”/419mm (H) Weight (dry) 62lbs/28kg WL15 with Base Cabinet Width/Depth/Height 13”/330mm (W) x 16.5”/419mm (D) x 52.6”/1336mm (H) Weight (dry) 93lbs/42kg 16.5” 52.6” 36.1” 16.5” 13” ELECTRICAL SPECIFICATIONS ELECTRICAL SUPPLY 120V/60Hz, 1PH 15 Amp Service COMPONENT...
  • Page 7 The buttons will continue to blink and the inlet solenoid will remain inactive until the leaked water has been dealt with. The above picture shows the front user interface (UI) and control panel for the Waterlogic WL15 Water Dispenser. The three water selection buttons control what kind of water is dispensed (Hot/Cold/Sparkling or Hot/Cold/Ambient).
  • Page 8: Energy Saver Function

    ENERGY SAVER FUNCTION The Waterlogic WL15 is equipped with an Energy Saving function that allows the hot tank to cool be disabled during times of inactivity. The machine uses a photovoltaic sensor to gauge light levels in its surroundings. When the lights go out, the machine will turn off the hot tank after 10 minutes and will turn it on once the lights come back on.
  • Page 9 (48) months from the date of manufacture. Waterlogic Commercial Products, LLC (“Waterlogic”) based in the U.S.A. and its affiliated companies are not liable for any cost of removal, installation, transportation, or any other charges which may arise in connection with a warranty claim.

This manual is also suitable for:

Wl15-hca15-ct-hcs15-ct-hca

Table of Contents