Maintenance
7
3.2 Special filter
The Special filter (C) is placed under the lint filter (B).
Pull out the filters as far as possible.
Loosen the two nuts on the locking bracket.
It is also possible to reach the nuts from behind the filter (A). Demount the filter (A) and loosen
the two nuts on the locking bracket.
Remove the filters and clean the Special filter (C) with a vacuum cleaner.
②
A
fig.W00731
Note!
Replace the Special filter when needed. It can be vacuum cleaned up to four times.
Note!
Do not use water to clean the Special filter.
When remounting; position the Special filter (C) below the lint filter (B). Make sure the Special filter
(C) is in center position when inserting the filters on the filter bracket.
Make sure the filters are in position and below the locking bracket. Tighten the nuts on the locking
bracket, press the locking bracket down at the same time as tightening the nuts.
If the filter (A) has been demounted; remount the filter (A).