ASL INTERCOM VAR8 Installation Manual page 10

ENHANCED
AUDIO A OUTPUTS
(ON EXP8 ONLY)
STANDARD
(See pinout in
AUDIO OUTPUTS
4. Connect the rack and field cabling for the network interface (if the ANIC8 Network Interface Card
is used).
Wiring should be according to the diagram shown in
! !
compliance.
Figure 1 on page
describes the signals.
5. Connect the dual power supply (as appropriate) to the rear panel connector.
Section "2 Connections" on page
6. The installation is now complete and ready for system commissioning.
Refer to the Commissioning Guide
VAR8 / Variants - Installation Guide
ENHANCED
AUDIO B OUTPUTS
(ON EXP8 ONLY)
Table 1, page 13.)
5 shows details of each connector. Section
NETWORK UPSTREAM
NETWORK DOWNSTREAM
12 describes the signals.
[Table 2 - 3].
Issue: 01 complete, approved
Page 10 of 22
RS232
Figure 2
"2
POWER SUPPLY
GND +V GND +V
AUDIO MONITORING
CAN BUS
RS485
FAULT RELAY
on page 7 for EMC
Connections" on page 12