Safety And Precautions; Environmental; Esd; Emc - ASL INTERCOM VAR8 Installation Manual

5 Safety and
Precautions
5.1

Environmental

The temperature and humidity ranges shown
in the specifications for this product must not
be exceeded.
This equipment must not be installed in an
area that is subject to a corrosive atmosphere,
excessive moisture or may allow water or other
liquids to come into contact with the unit or its
external connections.
In the close proximity of some radio frequency
transmitters, the signal to noise ratio of this
product may be reduced. If this occurs, re-
location of the equipment or the signal cables
is recommended.
5.2

ESD

This product contains static-sensitive devices.
Observe ESD precautions when working on
the equipment with the cover removed.
5.3

EMC

EMC compliance is dependent on this unit
being wired in accordance
installation instructions.
5.4

Electrical Safety

Always replace blown fuses with
!
!
the correct type and rating.
Ensure adequately rated cables
!
!
are used for power supply.
VAR8 / Variants - Installation Guide
5.5
5.6
The equipment should be unpacked and
inspected immediately on receipt. If damage
has occurred please advise your carrier or
supplier.
It is advisable to retain the original equipment
packing in the event that the equipment ever
needs returning for service.
Ensure that the name and address of the
Authorised
purchased the unit is recorded on the
and
reference.
5.6.1
with these
Advice on packing the product for return can
be provided by Application Solutions Limited.
Issue: 01 complete, approved
Page 20 of 22

Lithium Battery

Danger of explosion if battery is
!
!
incorrectly replaced. Replace only
with the same or equivalent type.
Dispose of battery carefully to
avoid environmental damage. Do
not dispose of battery in a fire.
Unpacking and
Handling
Distributor from
Warranty" page of this manual for future

Packing for Repair

All electronics assemblies must be
!
!
properly packed in ESD protective
packing for transport, to prevent
physical and ESD damage. Use of
non-ESD protective packing for
return for repair or service will
automatically
warranty.
The filler material used for packing
!
!
for return for repair must be
antistatic or static dissipative, as
this may come into contact with
exposed connectors, wiring, or
PCB assemblies. The use of non-
conductive filler
cause damage to the electronic
assemblies reducing
operational life, or even destroying
them, and it will automatically
invalidate the warranty.
whom you
"Service
invalidate the
material may
their