Installation - CDA 3C9 Extractor Manual For Installation, Use And Maintenance

Installation

Your extractor can be used to filter and recycle the air within
your kitchen, or to extract the air outside. When extracting air
to the outside, the unit can be vented as shown in the diagram
below. Note that we recommend the use of ducting with a
diameter of 150mm. Ducting with diameters of 100mm or
120mm may be used, but performance will be reduced.
Note that this product is heavy and should be installed
by two persons
The clearance between the underside of the extractor and
any hob underneath must be equal to or exceed 750mm (For
electric hobs, this height can be reduced to 650mm, but is
not recommended)
IN THE ABSENCE OF ANY INSTRUCTIONS SUPPLIED
WITH THE HOB, THE MINIMUM DISTANCE BETWEEN
THE HOB AND EXTRACTOR MUST BE AT LEAST 760mm
Fitting your extractor to the wall:
Before commencing, remove both the grease filters as shown
in figure 8 and the top cover (Fig 13).
7
750mm
Fig. 12
Fig. 13