ZyXEL Communications UAG4100 User Manual page 26

Table 6 Configuration Menu Screens Summary (continued)
FOLDER OR LINK TAB
Wireless
Controller Configuration
AP Mgnt. AP List
Management
Network
Interface Port Role
Ethernet
PPP
VLAN
Bridge
Trunk
Routing Policy Route
Static Route
Zone
DDNS
NAT
VPN 1-1 General
Mapping
Profile
HTTP Redirect
SMTP Redirect
ALG
UPnP
IP/MAC Summary
Binding
Exempt List
Layer 2 General
Isolation
White List
IPnP
Web Web Authentication
Authentication
Walled Garden
Adverstisement
Firewall Firewall
Session Limit
Billing General
Chapter 1 Introduction
FUNCTION
Configure how the UAG handles APs that newly connect to the
network.
Edit wireless AP information, remove APs, and reboot them.
Use this screen to set the UAG's flexible ports as LAN1 or LAN2.
Manage Ethernet interfaces and virtual Ethernet interfaces.
Create and manage PPPoE and PPTP interfaces.
Create and manage VLAN interfaces and virtual VLAN interfaces.
Create and manage bridges and virtual bridge interfaces.
Create and manage trunks (groups of interfaces) for load
balancing.
Create and manage routing policies.
Create and manage IP static routing information.
Configure zones used to define various policies.
Define and manage the UAG's DDNS domain names.
Set up and manage port forwarding rules.
Enable and configure VPN 1-1 mapping to assign a public IP
address to each of users that match the rules.
Configure a pool profile which defines the public IP address that the
UAG assigns to the matched users and the interface through which
the user's traffic is forwarded.
Set up and manage HTTP redirection rules.
Set up and manage SMTP redirection rules.
Configure SIP, H.323, and FTP pass-through settings.
enable UPnP and NAT-PMP on your UAG.
Configure IP to MAC address bindings for devices connected to
each supported interface.
Configure ranges of IP addresses to which the UAG does not apply
IP/MAC binding.
Enable layer-2 isolation on the UAG and the internal interface(s).
Enable and configure the white list.
Enable IPnP on the UAG and the internal interface(s).
Define rules to force user authentication for network access.
Create walled garden links that display in the login screen.
Enable and set advertisement links.
Create and manage level-3 traffic rules.
Limit the number of concurrent client NAT/firewall sessions.
Configure the general billing settings, such as the accounting
method.
UAG4100 User's Guide
26