ZyXEL Communications UAG4100 User Manual page 244

Figure 166 Configuration > Firewall > Add
The following table describes the labels in this screen.
Table 109 Configuration > Firewall > Add
LABEL DESCRIPTION
Create new Use to configure any new settings objects that you need to use in this screen.
Object
Enable Select this check box to activate the firewall rule.
From For through-UAG rules, select the direction of travel of packets to which the rule applies.
To any means all interfaces.
Device means packets destined for the UAG itself.
Description Enter a descriptive name of up to 60 printable ASCII characters for the firewall rule. Spaces
are allowed.
Schedule Select a schedule that defines when the rule applies. Otherwise, select none and the rule is
always effective.
User This field is not available when you are configuring a to-UAG rule.
Select a user name or user group to which to apply the rule. The firewall rule is activated
only when the specified user logs into the system and the rule will be disabled when the user
logs out.
Otherwise, select any and there is no need for user logging.
Note: If you specified a source IP address (group) instead of any in the field below, the user's
IP address should be within the IP address range.
Source Select an IPv4 address or address group to apply an IPv4 rule to traffic coming from it.
Select any to apply an IPv4 rule to all traffic coming from IPv4 addresses.
Destination Select an IPv4 address or address group to apply an IPv4 rule to traffic going to it. Select
any to apply an IPv4 rule to all traffic going to IPv4 addresses.
Service Select a service or service group from the drop-down list box.
Chapter 25 Firewall
UAG4100 User's Guide
244