ZyXEL Communications UAG4100 User Manual page 100

The following table describes the labels in this screen.
Table 41 Monitor > Log
LABEL DESCRIPTION
Show Filter / Hide Click this button to show or hide the filter settings.
Filter
If the filter settings are hidden, the Display, Email Log Now, Refresh, and Clear Log
fields are available.
If the filter settings are shown, the Display, Priority, Source Address, Destination
Address, Source Interface, Destination Interface, Service, Keyword, Protocol
and Search fields are available.
Display Select the category of log message(s) you want to view. You can also view All Logs at
one time, or you can view the Debug Log.
Priority This displays when you show the filter. Select the priority of log messages to display. The
log displays the log messages with this priority or higher. Choices are: any, emerg,
alert, crit, error, warn, notice, and info, from highest priority to lowest priority. This
field is read-only if the Category is Debug Log.
Source Address This displays when you show the filter. Type the source IP address of the incoming packet
that generated the log message. Do not include the port in this filter.
Destination This displays when you show the filter. Type the IP address of the destination of the
Address incoming packet when the log message was generated. Do not include the port in this
filter.
Source Interface This displays when you show the filter. Select the source interface of the packet that
generated the log message.
Destination This displays when you show the filter. Select the destination interface of the packet that
Interface generated the log message.
Service This displays when you show the filter. Select the service whose log messages you would
like to see. The Web Configurator uses the protocol and destination port number(s) of the
service to select which log messages you see.
Keyword This displays when you show the filter. Type a keyword to look for in the Message,
Source, Destination and Note fields. If a match is found in any field, the log message
is displayed. You can use up to 63 alphanumeric characters and the underscore, as well
as punctuation marks ()' ,:;?! +-*/= #$% @ ; the period, double quotes, and brackets
are not allowed.
Protocol This displays when you show the filter. Select a service protocol whose log messages you
would like to see.
Search This displays when you show the filter. Click this button to update the log using the
current filter settings.
Email Log Now Click this button to send log message(s) to the Active e-mail address(es) specified in the
Send Log To field on the Log Settings page (see
Refresh Click Refresh to update this screen.
Clear Log Click this button to clear the whole log, regardless of what is currently displayed on the
screen.
# This field is a sequential value, and it is not associated with a specific log message.
Time This field displays the time the log message was recorded.
Priority This field displays the priority of the log message. It has the same range of values as the
Priority field above.
Category This field displays the log that generated the log message. It is the same value used in
the Display and (other) Category fields.
Message This field displays the reason the log message was generated. The text "[count=x]",
where x is a number, appears at the end of the Message field if log consolidation is
turned on (see Log Consolidation in
aggregated to generate into this one.
Chapter 7 Monitor
Table 198 on page
UAG4100 User's Guide
100
Section 41.3.2 on page 407).
409). and multiple entries were