The Pincode System - Bang & Olufsen BeoVision 7 Manual

20
The pincode system is intended to
make normal use of your television
impossible for someone who does
not know the pincode. You choose
whether or not to activate the
pincode system.
When the pincode system is activated
and the television has been
disconnected from the mains for 15–
0 minutes, the pincode system goes
into effect.
When reconnected and switched on,
the television automatically switches
itself off after four minutes. Entering
the pincode returns the television to
normal.
Note: If you change your pincode more than
five times within a three-hour period, the
PINCODE menu becomes inaccessible for three
hours, assuming that the television is not
disconnected from the mains. Disconnecting
the television resets the three-hour period.

The pincode system

Activate the pincode system
PINCODE
PINCODE 0 . . .
CONFIRM PINCODE . . . .
next
accept
PINCODE
DELETE PINCODE
NEW PINCODE
select
If you wish to deactivate the pincode system,
you can do so by deleting your pincode.
To activate the pincode system ...
> Press Menu to bring up the TV SETUP menu.
> Press twice, followed by STOP. The PINCODE
menu appears on the screen.
> Press and use the number buttons on Beo5
GO
to enter the four digits of your code. (Beo4: Use
the number buttons).
> Press the centre button after the last digit is
found. (Beo4: Press GO).
> Re-enter your code to confirm it and press the
centre button again. If the two codes are not
identical, the input fields are cleared and you
must enter the code again. (Beo4: Press GO).
To change or delete your pincode ...
> Press Menu to bring up the TV SETUP menu.
> Press twice, followed by STOP. The PINCODE
menu appears on the screen.
> Enter the correct pincode and press the centre
button. DELETE PINCODE is highlighted. (Beo4:
Press GO).
> To delete your code, press the centre button.
GO
(Beo4: Press GO).
> To change your code, press to highlight
NEW PINCODE and press the centre button.
(Beo4: Press and GO). Press
new code using the number buttons and press
the centre button. (Beo4: Use the number
buttons and press GO). Re-enter the new code
to confirm it.
If you inadvertently press a wrong button while
entering a code, press STOP. The entry is
cancelled and the input fields are cleared.
, enter the