Installation; Using The Adjustable Mount; Installation Options; Rubber Bumper Feet - MartinLogan Stage X User Manual

Using the Adjustable Mount

For optimum performance the Stage X must be tilted on its stand
towards the main listening position and directed towards the
audience's ears (see figure 3). After you have placed your Stage X
in its final location, loosen the 2 knobs located on the stand arm,
pivot the Stage X towards the main listening position, and then
re-tighten the knobs.
The stand shipped with the Stage X loudspeaker is
designed for use only with the Stage X. Use with
other appliances may result in instability causing pos-
sible injury.

Installation Options

On the Television
If your television provides a wide, level and stable platform, the
shielded Stage X can be placed directly on top of the television
(see figure 3). For this option we recommend installation of the

rubber bumper feet.

On the Wall
The adjustable mount (stand) allows you to mount the Stage X
on the wall (see figures 2 and "Mounting the Stage X On A
Wall,"). If hanging the Stage X on the wall is the best placement
for your system, the adjustable mount (stand) will allow you to
tilt the Stage X towards the listening position.
Stage X
Figure 2. installation on the floor, on a television and on a wall.
On the Floor
Placing the Stage X on the floor might position it too low to
blend with the front speakers. (see figure 3). If placing the
Stage X on the floor is the best placement for your system,
the adjustable mount (stand) will allow you to tilt the Stage X
towards the listening position. For this option we recommend
installation of the rubber bumper feet.
WARNING! Installation other than that described in
the body of this document requires specific documen-
tation from MartinLogan.
Rubber Bumper Feet
If you are using the Stage X on top of your television, or setting
it on any type of surface, we recommend installing the 4 rub-
ber bumper feet included with the Stage X. The Stage X ships
with these 4 rubber bumper feet installed. The following instruc-
tions describe how to install the feet if they have been previously
removed for another installation.
Rubber Bumper Feet Installation Instructions:
1. Prepare a surface to work on by laying down a towel or large
soft cloth on top of a large flat surface.
2. Securely tighten the 2 knobs on the Stage X stand, making
sure the Stage X cabinet is level with the stand.
3. Turn the Stage X upside down so that the bottom of the stand
is pointing up.
4. Insert the 4 rubber bumper feet in the 4 holes on the bottom
of the stand.
I
nstallatIon

Installation

21