Setup Menu Appears - IBM 3151 Manual To Operations

Solving Problems
Setup Menu Appears
Note: If the video element is new and the setup-value Save operation has 110t
been performed, this menu normally appears on the screen.
1
Is your IBM 3151 new or has the llideo element been replaced?
Yes Go to step 6.
No Go to step 2.
2
Select the
FUNCTION
menu by pressing the Send key three times.
3
Select the Save field using the Cursor Atave keys
(i
1
+- --'),
then press the
Space Bar.
4
Set the power switch to 0 (Off); wait ten seconds.
~
Set the power switch to I (On).
Does the setup menu reappear on the screen?
Yes The video element is failing. Replace the video element. See page
5-20 for instructions.
No Go to step 6.
6
Perform the setup-value definitions. See "Defining Setup Values" on
page 2-14 for details. If you use an emulation cartridge, see the emulation
guide shipped with the cartridge.
Note: Remember to select the Save field and press the space bar to
complete the setup operation. Otherwise the setup menu will reappear the
next time power is turned on.
5-8
IBM 315J Guide to Operations