Envirovent heatSava Installation Manual page 17

05 Installation
Installation Process - Front Cover
Fig.13A
Take the front cover and connect the fan leads together
(Fig.13A).
Fig.14A
Click and shut the front cover, and fix it in place using the
screw. Place the fan badge on the front cover (Fig.14A).
AFTER INSTALLING THIS UNIT PLEASE LEAVE THIS INSTALLATION GUIDE WITH THE USER
DO NOT THROW AWAY
Fig.13B
Ensure the fan leads are neatly tucked down the side and do
not trap them against the end of the cell before putting the front
cover on (Fig.13B).
Fig.14B
Tidy the mains cable and if required use conduit etc. Make the
electrical connection via a fused spur and switch the unit on
and leave to run in trickle mode. Use the pullcord to test trickle
and boost modes (Fig.14B).
16